Perfect for applications on any hard, smooth surface including glass, ceramic, sealed wood, hard plastic, sealed painted surfaces, resin, metal and more. Can be used on light and dark coloured backgrounds. Interior and exterior use.

They are NOT suitable on paper, canvas or card-stock.

• The initial 24 hours following application are crucial, as this is when the adhesion gains strength. To achieve optimal results, it is recommended to avoid exposure to water or during this time.
• Avoid touching the adhesive side of the transfer to prevent fingerprints and ensure proper adhesion.
• Store unused transfers in a cool, dry place to maintain their quality and prevent damage.
• By removing 1-2 cm of the backing paper ( larger transfers) and trimming it, you gain better control during the application process. This  approach allows you to adhere the exposed adhesive section first before applying the entire transfer at once.  
• Always slowly remove the backing paper, peeling too quickly can cause lifting or damage to the design 
• While they are durable, we recommend hand-washing for the longest-lasting results.
• Take your time during alignment. Once placed, the transfer can not be repositioned.
• They work best on any hard, smooth non porous surfaces including glass ( not frosted ) ceramic, sealed wood, hard plastic, vinyl, metal and painted surfaces. Apply a lacquer to painted surfaces and bare wood first.
• For items like glassware, hand-wash with mild soap and avoid abrasive sponges.
• Do not put items that have been decorated in the microwave or dishwasher.
• Avoid using frosted glass.
  •  

Clean your smooth hard surface with rubbing alcohol or hot soapy water to remove dust oils and fingerprints Allow the surface to dry completely before applying.

Cut around the image, leaving a small border. This gives you an edge to hold without touching the image.

Before the next step, check the position and alignment of your transfer, once applied, it cannot be repositioned.

Gently peel away the white backing sheet, taking care not to touch the exposed adhesive.

Hold the transfer in a “U” shape, Allow the centre to touch the surface first, then slowly roll the sides down. Using a squeegee, credit card, or your fingers, firmly rub over the entire image 4-5 times to ensure good adhesion. Allow it to rest for about 1 minute..

Slowly peel the clear film back at a low flat angle Paying attention to the edges and intricate details If any part of the image remains on the clear film gently press it back down rub firmly and peel again from a different angle Once the film is removed gently rub over the entire image with your finger or a soft cloth Allow your finished item to sit for 24 hours before regular use giving the adhesive time to fully bond NO SEALING REQUIRED